Preparing surfaces for gluing or taping

Before attaching magnets, sensors or the device bracket with glue or double-sided tape, it is essential to prepare the surfaces correctly to achieve good adhesion.

1. Choose mounting location

   Ensure that the component you're mounting has sufficient space and is in a convenient position.

2. Abrade the surface(s)

   Sand the surface using medium-grit sandpaper (120-180 grit). This mechanical surface preparation increases adhesion by creating a larger contact area. If you're gluing, abrade both surfaces.

3. Clean the surface

   Use a solvent which doesn't leave any residue behind, e.g. denatured alcohol. Make sure the solvent does not damage the surface you're preparing. If you're gluing, clean both surfaces.

4. Done

   Go ahead and mount your component!